一、墻面與地面的接縫處
First, the wall and floor joints
水容易在此處堆積并從接縫處滲漏，施工時應先處理做成R角自動化生產線，如許不僅方便（屋頂）防水漿料涂刷，也能有用防止滲漏。
Water is easy to pile up here and leakage from the joints, the construction should be processed to make R angle, so that not only facilitate the waterproof slurry brushing, but also effectively prevent leakage.
二、地漏、穿管周邊
Two, floor drain, pipe around
地漏、穿管周邊是漏水的高發區域，施工前可使用老頑固速凝型堵漏劑進行（屋頂）防水增強處理，之后再涂刷（屋頂）防水漿料。
Floor drain, pipe is a high incidence of leakage around the region, before the construction can be used to speed up the old stubborn condensate plugging agent to strengthen the water treatment, and then coated waterproof slurry.
三、陰陽角
Three, yin and yang angle
陰角、陽角部位是應力集中處，國家有規范要求，這些部位應做成倒圓弧角減小應力。因此，先將陰陽角部位進行圓弧處理（做成R角），避免（屋頂）防水層受垂直方向的力而被撕裂。
The angle of the Yin and yang angle is the stress concentration, the state has the standard requirements, these parts should be made to reduce the stress of the arc angle. Therefore, the first part of the Yin and yang angle arc processing (made of R angle), to avoid the water layer by the vertical direction of the force was torn.
四、鋪設冷熱水管的鑿溝
Four, laying hot and cold water pipes
施工前將鑿溝內的石子、灰塵等清理干凈，用砂漿抹平壓實，然后過細涂刷屋頂防水漿料。
Before the construction of the trench trench gravel, dust and other clean up, with mortar smoothing compaction, and then carefully coated waterproof slurry.
五、門框
Five, door frame
做好了衛生間地面和墻面的（屋頂）防水，別忘了在門框和門檻處涂刷屋頂防水漿料（百度網站優化），防止水向外滲漏到墻壁和地板，造成損壞。
Do a good job on the bathroom floor and wall of water, do not forget to paint the door and the threshold of waterproof paste, to prevent leakage of water to the walls and floors, causing damage.
