1 下層應結實、平整。鏟除疏松結構、清除油脂和其他妨礙下層與涂料粘結的物質。
1 grassroots should be firm, smooth. Eliminate loose structure, remove grease and other substances that interfere with the adhesion between the substrate and the coating.
2 孔洞用砂漿修平。裂縫適當鑿寬，然后用薇妮聚合物柔性屋頂防水涂料漿料填平。
2 holes with mortar leveling. And then use the appropriate cut crack width, filled vennytex polymer flexible waterproof coating slurry.
3垂直交界面用薇妮聚合物柔性屋頂防水涂料修成斜坡面。
3 vertical interface with vennytex flexible polymer waterproof coating into slope.
4 施工前基面用水沖洗干凈。
4 before the construction of surface water rinse.
5 需增強部位：陰陽角、板端縫、結構裂縫、后澆縫、變形縫等均需做增強屋頂防水處理。
5 need to strengthen the parts: Yin and yang angle, the end of the plate joints, structural cracks, after pouring joints, deformation joints are required to do to strengthen the water treatment.
6 增強屋頂防水層工法：在已填平縫隙或已做成斜坡面的基面上涂刷一道薇妮聚合物柔性屋頂防水涂料，當其仍然潮濕狀態時（成都人事考試網首頁），加鋪一層防水聚酯布（烤藍鋼帶），用刷子刷平整，不留皺折或氣泡。再加涂一層同樣涂料，使其浸透防水聚酯布。做室外停車場和橋面屋頂防水時，應根據當地氣溫條件選用對應涂料。
6 strengthen the waterproof layer technology: on the surface of the base has filled gaps or has been made on the slope of a flexible polymer waterproof paint, when it is still wet trend, paving a layer of polyester nonwoven fabric, with scraper scraping, leaving no wrinkles or bubbles. And then coated with a layer of the same paint, so that the non-woven fabric. When the outdoor parking and bridge deck waterproofing, should be selected according to the local temperature conditions.
7在處理好的基面上輥涂一道薇妮聚合物柔性屋頂防水涂料，當其仍然潮濕狀態時，加鋪一層防水聚酯布，用刷子刷平整，不留皺折或氣泡。再加涂第二層同樣涂料，使其浸透防水聚酯布。聚酯布布之間的搭接寬度為10cm。
7 in good surface treatment on the roller coating a flexible polymer waterproof coating, when it is still wet trend, paving a layer of polyester nonwoven fabric, with scraper scraping, leaving no wrinkles or bubbles. And then coated with second layers of the same paint, so that the non-woven fabric. The overlap width between non-woven fabrics is 10cm.
網站建設費用
